The SCP cutting press is used to cut various papers with minimum effort. The cutter allows you to cut several sheets of paper at the same time.

We supply different size attachments allowing you to cut all of the G Series badge sizes.

Adjustable to fit a variety of dies. Due to the nature of the mechanics, it can cut up to 50 sheets at a time with minimum effort.

Technical Information and Dimensions

Dimensions of machine: 530 x 310 x 500 mm
Large capacity cutting press
For cutting paper only
Comes with nylon base cutting surface
Die cuts manufactured exclusively for this machine and can be purchased separately
Manufactured following European quality standards
Fully adjustable to suit particular dies
Easy pull down action
Easy to use
Comes with wooden base

Assembly Instructions

Before using the machine the die cuts will need adjusting
Place your printed paper onto the nylon base and place your chosen die cut over the print and under the central lever
Pull the lever until the plunger reaches the top of the die
Adjust the plunger clockwise until it connects with the die
It is important to make sure the lever is full to the lowest point
Once adjusted, release the lever and give an extra half turn to the plunger
Test the cutting process by pulling down the lever giving a light pressure over the die to cut the paper
If the test cut is perfect the machine has been correctly adjusted, if not please start the adjustment process again
Please be aware if too much pressure is applied the paper and die may get stuck in the nylon base and shorten the lifetime of the machine
Once happy with the adjustment, tighten the screw on the plunger
Take your paper ready to be cut, place the selected die cutter over the top, place under the plunge and press the lever down with little pressure on the handle

Round Cutters